Husqvarna CTH1736 用户手册

•  Slightly loosen the nuts securing the bagger RH and 

LH hor i zon tal adjustment brackets. Loosen only enough 

so the brackets keep their position, but allow them to 

be moved.  

• 

Move the brackets the amount forward or back ward you 

wish the bag assembly to move. Retighten the  nuts 

securely. 

•  Slightly loosen the nuts securing the vertical adjust-

ment brackets. Loosen only enough so the brackets 

keep their position, but allow them to be moved. 

• 

Move the brackets the amount up or down you wish the 

bag assembly to move. Retighten the nuts securely. 

•  Reinstall the bagger as sem bly and check the bagger 

to fender fit.  If necessary, repeat the procedure until 

proper fit is attained.

•  After proper fit is attained, remove bagger from trac-

tor and install bagger latch (4) to tractor back plate as 

shown. Tighten securely.

•  Install and carefully lower bagger to actuate latch.
•  Measure distance between bagger and latch as 

shown. 

If distance is not 10mm - 16mm carefully remove bagger
and repeat vertical adjustment as needed.

02983

•  Remove spring retainer  and pin from handle.
•  Insert plug into handle. Make sure that the letter "A" 

on both the plug and handle are on the same side and 

that they can both be seen from the top when laying 

on the ground.

•  Secure with pin and retainer spring provided. For in-

 stal la tion see "To Convert Mower" in Section 5 of this 

manual.

02

21

4