Husqvarna 532 42 57-62 用户手册

(2) Keys

(1) Oil Drain Tube 

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

•  Sit in seat.
• 

Lift up adjustment lever (A) and slide seat until a com-

fortable position is reached which allows you to press 

clutch/brake pedal all the way down.

•  Release lever to lock seat in position.

NOTE: You may now roll your tractor off the skid. Follow the 

instructions below to remove the tractor from the skid.

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.
(1)  1/2" wrench 

Tire pressure gauge

(2)  7/16" wrenches 

Utility knife

  

Pliers

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

•  Lift hood to raised position.
NOTE: If this battery is put into service after month and 

year indicated on label (label is located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging instructions).
•  For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments" 

section in this manual.

•  Remove all accessible loose parts and parts cartons  

from carton .

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Check for any additional loose parts or cartons and 

remove.