Husqvarna 335RJx 用户手册

English

 –

 13

The guard extension is removed easily using the spark 
plug spanner, see illustration.

•

Hook the blade guard/combination guard (A) onto the 
fitting on the shaft and secure with the bolt. CAUTION!  
Ensure that the guard extension is removed.

Use the recommended blade guard. See the 
Technical data section.

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D), support cup (E) and support 
flange (F) on the output shaft.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 
the spanner in the opposite direction to the direction of 
rotation (Caution! left-hand thread). 

•

Fit the trimmer guard/combination guard (A) intended 
for use with the trimmer head/plastic blades. 
CAUTION!  Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the 
two hooks on the plate holder (M). Bend the guard 
around the shaft and tighten it with the bolt (L) on the 
opposite side of the shaft. Use the locking pin (C). 
Place the locking pin in the groove on the screw head 
and tighten. See diagram.

•

Fit the drive disc (B) on the output shaft. 

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse 
order.

H

H