Husqvarna 308 用户手册

English - 17

• Transformer (20)

• Low voltage cable (17)

• Staples (21)

• Connector for connecting the loop wire to the 

charging station (18)

• Screws for the charging station (19)

• Measurement gauge (22)

• Couplers for the loop wire (23)

During installation you will also need: 

• Hammer/plastic mallet (to simplify putting the 

staples in the ground).

• Combination pliers for cutting the boundary 

wire and pressing the contact strips together.

• Edge cutter/straight spade if the boundary wire 

must be buried. Installation of the charging 
station. 

Take the following aspects into consideration when 
identifying the best location for the charging station:

• Allow for 3 metres of free space in front of the 

charging station.

• It must be possible to lay at least 1.5 metres of 

boundary wire straight out to the right and left 
of the charging station.

• It must be close to a wall socket The supplied 

low voltage cable is 10 metres long. 
A 20 meter low voltage cable is available to 
purchase as an accessory. Please contact 
your dealer for more information.

• A level surface to place the charging station 

on.

• Protection from water spray for instance from 

irrigation.

• Protection from direct sunlight.

• Place in the lower part of a working area that 

has a major slope.

For an example of an ideal position of the charging 
station, see 7. Garden examples on page 53.

3018-057

3018-072