Husqvarna 308 用户手册

English - 49

The Test IN function allows you to test how well the 
robotic lawnmower docks with the charging station.

Test IN can only be performed after Test OUT has 
been performed. 

Selecting this function causes the mower to travel 
directly along the guide wire towards the charging 
station and docks with it. The test is approved only if 
the mower is able to dock with the charging station at 
the first attempt. If the mower is unable to dock on the 
first attempt, it will automatically try again. The 
installation is not approved if the mower needs two or 
more attempts to dock with the charging station.

The front of the mower always passes the boundary 
wire by a specific distance before the mower turns. 
The default distance is 25 cm, but this can be 
changed if required. The minimum value is 25 cm and 
the maximum value is 30 cm.

Now specify the number of centimetres you want the 
mower to pass the boundary wire and press OK.

Through this selection, settings relating to security 
and the connection between the mower and the 
charging station can be made.

Enter the new PIN code and press OK. Enter the 
same code again and confirm by pressing OK. When 
the PIN code is changed, a message stating that the 
PIN code has been changed appears in the display 
momentarily.

Make a note of the new PIN code on the designated 
line in Memo on page 4.