Husqvarna 308 用户手册
66 - English
9. TROUBLESHOOTING
9.2 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid green light.
If something else appears, follow the troubleshooting guide below.
If something else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting,
please contact the local dealer.
please contact the local dealer.
Light
Cause
Action
Solid green light
Everything in order
No action required
Blue flashing light
The boundary wire is not connected
to the charging station
to the charging station
Check that the boundary wire
connector is fitted properly to the
charging station. See 3.5 Connecting
the boundary wire on page 28.
connector is fitted properly to the
charging station. See 3.5 Connecting
the boundary wire on page 28.
Break in the boundary wire.
Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice
using an original coupler.
the damaged section of the boundary
wire with a new loop wire and splice
using an original coupler.
Yellow flashing light
The guide wire is not connected to
the charging station
the charging station
Check that the guide wire connector
is properly connected to the charging
station. See 3.6 Installation of the
guide wire on page 29.
is properly connected to the charging
station. See 3.6 Installation of the
guide wire on page 29.
Break in the guide wire
Find out where the break is. Replace
the damaged section of the guide
wire with a new loop wire and splice
using an original coupler.
the damaged section of the guide
wire with a new loop wire and splice
using an original coupler.
Red flashing light
Interruption in the charging station's
antenna
antenna
Contact the local dealer.
Solid blue light
Weak signal as the boundary wire is
too long. Max length is 250 metres.
too long. Max length is 250 metres.
No steps have to be taken if the
mower operates as expected.
mower operates as expected.
Shorten the boundary wire by
reducing the working area or
replacing islands with barriers the
mower can collide with.
reducing the working area or
replacing islands with barriers the
mower can collide with.
Weak signal due to damaged
boundary wire
boundary wire
Since it is difficult to locate where the
wire is damaged it is recommended
to lay a new boundary wire for the
entire working area.
wire is damaged it is recommended
to lay a new boundary wire for the
entire working area.
Solid red light
Defective circuit board in the charging
station
station
Contact the local dealer.