Husqvarna CTH2542 TWIN 用户手册

02614

TO REMOVE CABLES, REVERSE ORDER -

•   BLACK cable first from chassis and then from the fully 

charged battery.

•   RED cable last from both batteries.

WARNING:  Lead-acid batteries gen-

If your battery is too weak to start the engine, it should be 

recharged. (See "BATTERY" in the MAINTENANCE sec-

 tion of this man u al).
If “jumper ca bles” are used for emer gen cy starting, follow 

this pro ce dure:

IMPORTANT:  YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT 

SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT 

SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START 

OTHER VEHICLES. 

TO ATTACH JUMPER CABLES -

•   Connect one end of the RED cable to the POSITIVE 

(+) terminal of each battery(A-B), taking care not to 

short against tractor chassis.

•    Connect one end of the BLACK ca ble to the NEGA TIVE 

(-) terminal (C) of fully charged battery.

•   Connect the other end of the BLACK cable (D) to good 

chassis ground,  away from fuel tank and bat tery.

03076

• Raise 

hood.

•  Unsnap headlight wire connector.
• 

Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•  To replace, reverse above procedure.

The throttle control has been preset at the factory and 

ad just ment should not be necessary.  If adjustment is 

necessary, see engine manual.

The carburetor has been preset at the factory and ad just ment 

should not be necessary.  However, minor ad just ment may be 

required to compensate for differences in fuel, temperature, 

altitude or load.  If the carburetor does need adjustment, 

see engine manual.

• Raise 

hood.

•  Pull bulb holder out of the hole in the backside of the 

grill.

•  Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

• Close 

hood.

Loose or damaged wiring may cause your tractor to run 

poorly, stop running, or prevent it from starting.
•  Check wiring.  See electrical wiring diagram in the 

Repair Parts section.

Replace with 20 amp automotive-type plug-in fuse.  The 

fuse holder is located behind the dash.

•  On rear wheels only:  align grooves in rear wheel hub 

and axle.  Insert square key.

•  Replace washers and snap retaining ring securely in 

axle groove.

•  Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to 

slow leaks, tire sealant may be purchased from your local 

parts dealer. Tire sealant also prevents tire dry rot and 

corrosion.