Husqvarna 325RDX 用户手册
English
– 13
ASSEMBLY
1151416-95 Rev. 1 2008-12-23
Assembling and dismantling the
two-piece shaft (325RDx)
two-piece shaft (325RDx)
Assembly
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on the
coupling (B).
coupling (B).
•
Push the attachment into the coupling until the attachment
snaps into place.
snaps into place.
•
Before using the unit, tighten the knob securely.
Dismantling
•
Loosen the coupling by turning the knob (at least 3 times).
•
Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.
engine end, pull the attachment straight out of the
coupling.
Assembling the cutting equipment
Fitting a blade guard, grass blade
and grass cutter
and grass cutter
•
Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
fitting on the shaft and secure with the bolt.
CAUTION! Use the recommended blade guard. See the
Technical data section.
Technical data section.
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
A
B
C
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
!
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
the machine must be equipped with the correct handlebar,
blade guard and harness.
G
F
D
B
C
A
E