Husqvarna BZ6127D 用户手册

37

Dampeners must be free to pivot.

Distance between nuts (5/32” minimum) must 
be maintained so the dampener can pivot 
freely, both ends. See illustration.

Stop engine and remove key.

Pull the motion control lever back to the 
reverse position and release the lever. When 
the lever stops it should be in line with the 
neutral slot, so you can move the lever into 
neutral slot with out hitting the side of the 
console frame.

If adjustment is required put the seat in the 
rear most position on the slide, tilt the seat 
forward, remove the seat rod from seat frame 
and fold seat over forward onto the frame.

On the back of the console where the spring 
is fastened, loosen the 3/8” nut and bolt 
enough to allow the bolt to slide in the slot. 
See illustration.

This adjustment must be made with the rear 
wheels rotating. Raise the rear of the 
machine and block it up so the wheels are 
free to rotate.

Tilt seat forward and remove the seat rod so 
the seat may rotate forward onto the frame.

Place a 2 x 4 board between the foot plate 
and the center of the seat to engage the seat 
safety switch.

Loosen the nuts (A & B) directly behind each 
ball joint on linkages (C). See illustration.

Start the engine. The park brake must be 
engaged and the motion control levers in the 
neutral slots to start the engine. Run the 
engine approximately half throttle. Release 
park brake to allow the wheels to rotate.

Motion

Control

Lever

Reverse Detent
Adjustment Slot

Reverse Detent

Spring

Lever

Motion

Control

Turn Here to

Adjust

Pump Arm

Left Hand Threads

A

C

D

B

Dampener

Nuts