Husqvarna YTH2148 用户手册

SERVICE AND ADJUSTMENTS

FIG. 31

02778

HOOD

HEADLIGHT
WIRE
CONNECTOR

TO REPLACE HEADLIGHT BULB

• Raise hood.
• Pull bulb holder out of the hole in the backside of the

grill.

• Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

• Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the

Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 31)

•      Raise hood.
•      Unsnap headlight wire connector.
•         Stand in front of tractor. Grasp hood at sides, tilt toward

engine and lift off of tractor.

• To replace, reverse above procedures.

FIG. 29

WEAK OR DEAD
BATTERY

FULLY CHARGED
BATTERY

FIG. 30

REPLACING BATTERY (See Fig. 30)

WARNING: Do not short battery
ter mi nals by allowing a wrench or any
other object to contact both terminals
at the same time. Before connect-
ing battery, remove metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be connected
fi rst to prevent sparking from ac ci -
den tal grounding.

•      Lift hood to raised position.
•      Remove terminal guard.
•     Disconnect BLACK battery cable then RED battery

cable and carefully remove battery from tractor.

• Install new battery with terminals in same position as

old battery.

• Reinstall terminal guard.
• First connect RED battery cable to positive (+) battery

terminal with hex bolt and keps nut as shown. Tighten
securely.

• Connect BLACK grounding cable to negative (-) bat tery

terminal with remaining hex bolt and keps nut. Tighten
securely

• Close terminal access doors.
• Close hood.

0217

HEX BOLT

KEPS NUT

POSITIVE
(RED)
CABLE

NEGATIVE
(BLACK)
CABLE

TERMINAL
GUARD

TERMINAL
ACCESS
DOOR