Husqvarna YTH2748 用户手册

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
(2)  3/4" wrenches 

 

Pliers

(2)  7/16" wrenches 

 

Tire pressure gauge

    Utility 

knife

When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).

•      Remove all accessible loose parts and parts cartons  

from carton.

•     Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels fl at.

•     Check for any additional loose parts or cartons and 

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

Adjust seat before tightening adjustment knob.
•     Remove adjustment knob and fl at washer securing 

seat to cardboard packing and set aside for assembly 
of seat to tractor.

•         Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•    Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•      Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•      Pivot seat and pan forward and assemble adjustment 

knob and fl at washer loosely. Do not tighten.

•      Lower seat into operating position and sit on seat.
•     Slide seat until a comfortable position is reached 

which allows you to press clutch/brake pedal all the 
way down.

•      Get off seat without moving its ad just ed position.
•      Raise seat and tighten adjustment knob securely.

•     Remove locknut and large fl at wash er from steering 

shaft.

•      Position front wheels of the tractor so they are pointing 

straight forward.

•     Position steering wheel so cross bars are horizontal 

(left to right) and slide onto steering wheel adapter.

•     Secure steering wheel to steering shaft with locknut 

and large fl at wash er pre vi ous ly removed.  Tight en 
securely.

•     Snap steering wheel insert into cen 

ter of steering 

wheel.

•     Remove protective materials from tractor hood and 

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN 
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 
ROLL OFF SKID.

2771