Husqvarna Z18 用户手册

56

-English

Check the oil level in the engine when the machine 
is standing level and the engine is stopped.

Pull up the dipstick, wipe it clean and then replace it.

The dipstick must be fully pushed down.

Take the dipstick out again and read the oil level.

The oil level should lie between the markings on the 
dipstick. If the level is approaching the ”ADD” mark, 
fill with oil to the ”FULL” mark on the dipstick. 

Never fill to above the ”FULL” mark.

The oil is filled through the hole for the dipstick.

API class SF, S6, SH, SJ or higher must be used 
syntetic oil is recommended SAE 5W-20, 5W-30. 
Mineral oil can be used SAE 10W-30. The engine 
holds 1.6 qt/1.5 liters excl filter or 1.7 qt/1.6 liters 
including filter.

1.

Drain the engine oil following the 
procedure described in Engine Oil/
Change Engine Oil section. 

2.

Remove the oil filter. If necessary, use a 
filter remover.

3.

Wipe new, clean engine oil on the seal of 
the new filter.

4.

Mount the filter by hand with + 3/4 turn.

5.

Run the engine warm, then check that 
there are no leaks around the oil filter 
seal.

6.

Check the oil level in the engine, fill 
if necessary. The oil filter holds 0.1 liters 
of oil.

The transmission is maintenance free. There 
is no need for level checks or oil changes. If a 
leak occurs, replace the unit or contact your 
Husqvarna dealer.

8009-159

8011-739