Husqvarna PZ29D CE 用户手册

下载
页码 72
SAFETY
17
WARNING!
This mower is equipped with an 
internal combustion engine and 
should not be used on or near any 
unimproved forested, bush covered 
or grassy lands unless the engine's 
system is equipped with a spark 
arrester meeting applicable local or 
state laws (if any).
Rollover Protection System (ROPS)
The ROPS increases the basic weight of the unit by 73 
lbs/33 kg.
•  Do not use the ROPS as a lifting, attaching or 
anchoring point.
•  Do not use the ROPS for wrecking or towing.
•  Do not exceed Max GVW: 2822 lbs/1283 kg.
•  Securely fasten the seat belt if the unit has a 
ROPS.
•  Where possible, avoid operating the unit near 
ditches, embankments and holes.
•  Reduce speed when turning, crossing slopes and 
on rough, slick or muddy surfaces.
•  Stay off slopes too steep for safe operation.
•  Be aware of the mowing path, especially at row 
ends, on roads and around trees.
•  Do not permit take passengers.
•  Operate the mower smoothly, make no jerky turns, 
starts or stops.
•  When the mower is stopped, set brakes securely 
and use the park brake.
•  If any part of the ROPS is damaged, the entire 
ROPS must be replaced.
•  Before each use, check for the correct torque on 
all bolts, including those on the seat belt.
•  Check the ROPS structure for damage before 
each use.
•  ROPS bar is NOT intended for use in sub zero 
temperatures.
WARNING!
The rollover protection system's 
capabilities may be impaired by 
damage if the mower is overturned 
or if alteration to the ROPS occurs. If 
these conditions take place, the total 
structure MUST be replaced.
Spark Arrestor
A spark arrester is standard equipment on the unit 
and is attached to the engine muffler. Clean the 
interior screen regularly, depending on usage and 
conditions.
The engine and the exhaust system become very hot 
during operation and there is risk for burns if touched.
Allow the exhaust system to cool to a safe 
temperature before cleaning the screen.
To clean, slide the spark arrestor screen out of the 
muffler. Clean the carbon from the screen with a soft 
brush or cloth.
Replace screen and reattach the tail pipe, orienting 
the tail pipe either horizontally or upwards, away from 
grassy surfaces.
WARNING!
The engine and the exhaust system 
become very hot during operation.
There is risk for burns if touched.
Allow engine and exhaust system 
to cool to a safe temperature before 
refueling.
8065-063
Regularly clean spark arrestor screen