Husqvarna PZ29D CE 用户手册

1

/

8

 - 

3

/

16

"

MAINTENANCE

42

Visually check that no damage is found on the lever, 
links, or switch belonging to the parking brake. 
Perform a standstill test and check that there is 
sufficient braking action.

8065-006

Parking Brake Adjustments
1.  Using a jack stand, raise the rear of the mower up 

off the ground. Make sure the machine is securely 
supported.

2.  Remove the rear tire assemblies.
3.  Release the park brake.
4.  Loosen the jam nuts from rear of the brake 

bracket approximately ½" (13mm).

5.  Loosen the nyloc nut until the threads on the 

linkage are flush with the end of the nut.

6.  Engage the park brake lever.
7.  Pull forward on the linkage until it stops against 

the brake on the wheel motor.  Be sure the linkage 
is not stopping against the jam nuts.

8.  Tighten the nyloc nut against spring until the 

spring no longer rotates freely.

9.  Turn the jam nuts until the front nut is 

1

/

8

" to 

3

/

16

" 

from the brake bracket.

10.  Tighten the rear jam nut against the front nut.
11.  Tighten the nyloc nut against the spring and brake 

bracket until the gap set in Step 9 is closed.

12.  Repeat the above steps on other side of the unit.
13.  Disengage and reengage the brake lever to test 

braking.

14.  Reinstall the drive tire assemblies.
15.  Remove jack and jack stands.

8065-078

1. Jam nuts
2. Brake bracket
3. Nyloc nut
4. Brake linkage
Parking brake adjustment