Husqvarna YTH2754T 用户手册

•  FIRST INSTALL ANTI-SWAY BAR (S). 

• 

From right side of mower, insert anti-sway bar into 

hole in transmission bracket (T).

•  Pivot bar towards you and insert other end of bar 

into hole in rear mower bracket (D). Move mower 

as needed to insert bar.

•  Secure with washer and retainer spring as shown 

•  ATTACH MOWER SIDE SUSPENSION ARMS (A) TO 

CHASSIS - Position hole in arm over pin (B) on outside 

of tractor chassis and secure with retainer spring.

•  Repeat on opposite side of tractor.

•  ATTACH REAR LIFT LINKS (C) - Lift rear corner of 

mower and position slot in link assembly over pin on 

rear mower bracket (D) and secure with washer and 

retainer spring.

•  Repeat on opposite side of tractor.
•  Turn steering wheel to position wheels straight forward.

•  ATTACH FRONT LINK (E) - Work from left side of tractor. 

Insert rod end of link assembly through front hole in trac-

tor front suspension bracket (F) and secure with retainer 

spring (G) through hole in link located behind the bracket.

• 

Insert other end of link (E) into hole in front mower bracket 

(H) and secure with washer and retainer spring (J).

•  Disengage belt tension rod (K) from locking bracket (L).

•  Install belt onto engine clutch pulley (M).

IMPORTANT:  Check belt for proper routing in all mower 

pulley grooves.  

• 

Engage belt tension rod (K) on locking bracket (L).

•  Raise attachment lift lever to highest position.
•  If necessary, adjust gauge wheels before op er at ing 

mower as shown in the Operation section of this manual.

MOWER DRIVE BELT INSTALLATION 
Follow procedure described in “TO REPLACE MOWER 

BLADE DRIVE BELT ” in the "Service and Adjustments" 

section of this manual.