Husqvarna PR 17 用户手册

24 – 

English

Clean the machine directly after use. It is much easier to wash 
off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. 
Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or 
bearings.

Do not rinse hot surfaces such as the engine and exhaust 
system.

It is recommended that you start the engine and run the 
mower for a short period after cleaning, so that any remaining 
water is blown off.

Lubricate the machine if necessary after cleaning. Carry out 
extra lubrication when the bearings have been exposed to a 
degreaser or a water jet.

There is a major risk of water penetrating into bearings and 
electrical connections. Corrosion attack can result, which will 
lead to running problems. Cleaning additives generally 
aggravate the damage.

Pull the seat forward to its foremost position. Fold up the seat.

Pull the snap catches on the engine cover backwards. The 
snap catches are located on the inside of the engine frame.

Open the engine cover forwards.

Release the clip on the front hood and lift off the fender.

The front cover is secured to the unit frame with two hooks.

Remove the accelerator knob (1), screws (2 and 3), and 
remove the cover.

Remove the screws holding the wing cover (2) and lift off the 
cover.

Undo the two screws (one on each side) and lift off the 
transmission cover.

Avoid using a high pressure washer or a steam cleaner.