Husqvarna P 525D 用户手册

English

 – 23

•

Loosen the lower mounting screw and upper adjustment 
screw a few turns.

•

Tension the belt by pulling the alternator along the track. It 
must be possible to press the belt in about 1 cm with your 
thumb without too much pressure.

•

Tighten the adjustment screw securely.

•

Loosen the lower mounting screw and upper adjustment 
screw a few turns.

•

Take off the old belt and fit the new one.

•

Tension the belt by pulling the alternator along the track. It 
must be possible to press the belt in about 1 cm with your 
thumb without too much pressure.

Check regularly that the muffler is complete and secured 
correctly.

Make sure the parking brake is properly adjusted by placing 
the machine on a slope.

Apply and lock the parking brake.

When the machine does not stand still, the parking brake 
should be adjusted according to the following.

1

Position the machine on flat ground.

2

Make sure the parking brake is released.

3

Adjust so there is 1 mm play between the outer cable and 
the adjuster screw when you pull the outer cable.

Adjust the adjuster screw using the nuts.

4

Tighten the nuts carefully to prevent damaging the 
adjuster screw.

5

The parking brake should be checked again after the 
adjustment has been made.

 P 520D and P 525D have two fuel filters. A pre-filter and main 
filter.

Replace the fuel filter every 100 hours (at least once per 
season) or more often if it is clogged.

The pre-filter is located under the battery box and is replaced 
as follows.

1

Open the engine cover.

2

Loosen the hose clips

3

Move the hose clips away from the filter. Use a pair of flat 
pliers.

4

Pull off the filter from the hose ends.

5

Press the new filter into the ends of the hoses.

6

Push the hose clips back on the filter and tighten.