Husqvarna P 525D 用户手册
English
– 33
Lubrication
Lubrication schedule
Legend for the lubrication schedule
Filter replacement
Oil change
Level check
Grease nipple
Oil can
Check belts, condition and belt tension
Belt replacement
General
Remove the ignition key to prevent unintentional movements
during lubrication.
during lubrication.
When lubricating with an oilcan, it ought to be filled with
engine oil.
engine oil.
When lubricating with grease, unless otherwise stated,
grease 503 98 96-01 or another chassis or ball bearing
grease offering good corrosion protection shall be used.
grease 503 98 96-01 or another chassis or ball bearing
grease offering good corrosion protection shall be used.
If the machine is used daily it should be lubricated twice a
week.
week.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the
drive surfaces on the belt pulleys. Should this happen,
attempt to clean them with spirits. If the belt continues to slip
after cleaning with spirits, it must be replaced.
drive surfaces on the belt pulleys. Should this happen,
attempt to clean them with spirits. If the belt continues to slip
after cleaning with spirits, it must be replaced.
Petrol or other petroleum products must not be used to clean
belts.
belts.