Husqvarna P 525D 用户手册

English

 – 37

•

Use the oil dipstick to check that there is oil in the 
transmission.

•

The oil level should be between the markings on the 
dipstick.

•

Refill as required with fully synthetic 10W/50 API SM oil or 
better

Lubricate front and rear knobs with oil.

Fold up the seat.

Lubricate the lever for longitudinal adjustment with oil.

Lubricate the longitudinal adjustment runners with grease. 
Pull the seat back and forth and lubricate on both sides.

Remove the cable´s rubber casing when lubricating.

Grease both ends of the cables and move the controls to end 
stop positions when lubricating.

Re-attach the rubber covers on the cables after lubrication.

Cables with sheaths will jam if they are not lubricated 
regularly. A jammed cable may cause malfunction, such as 
the parking braking being applied. If a cable binds, remove 
the cable and hang it vertically. Lubricate it with thin engine oil 
until the oil begins to escape from the bottom.

A tip: Fill a small plastic bag with oil and tape it so that it seals 
against the casing and allow the cable to hang vertically from 
the bag overnight. If you do not succeed in lubricating the 
cable, it must be replaced.

•

Remove the right side cover on the lever housing (3 
screws) and open the engine cover.

•

Lubricate the cables’ free ends with the oilcan, even those 
by the engine.

•

Move the controls to the end points and lubricate again.

Replace the lever housing’s side cover.

Remove the rubber cover and lubricate the cable with oil.