Husqvarna YTH2248 用户手册

The gauge wheels are designed to keep the mower deck 
in proper position when operating mower. Be sure they 
are prop er ly adjusted to ensure optimum mower per for -
mance. 
•      Slide gauge wheel bar down into bracket channel, Be 

sure that gauge wheel bar aligning holes are on top. 
As sem ble gauge wheels as shown using shoulder bolts, 
3/8 washers and 3/8-16 center locknuts and tighten 
securely.

•      Assemble brackets "A" and "B" to the inside of mower 

mounting brack ets as shown.  Tighten securely.

NOTE:  Be sure bracket tabs are positioned in tab holes 
in mower brackets.
•     Position nose roller between brackets and install rod 

and retainer spring.

•      Press lift lever plunger and raise attachment lift lever 

to its highest po si tion.

•      Release  parking  brake  by  de press ing clutch/brake 

ped al.

•     Place freewheel control in "trans mis sion dis en gaged 

position" (See “TO TRANS 

PORT” in the Op 

er a tion 

section of this manual).

•      Roll tractor forward off skid.

WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other peo ple and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•     Place freewheel control in "trans 

mis sion en 

gaged" 

po si tion (see "TO TRANSPORT" in Op er a tion section 
of this manual).

•      Sit on seat in operating position, depress clutch/brake 

pedal and set the parking brake.

•      Place motion control lever in neutral (N) position.
•      Press lift lever plunger and raise attachment lift lever 

to its highest position.

•         Start the engine. After engine has started, move throttle 

control to idle position.

•      Release parking brake.
•      Slowly move the mo tion control lever for ward and slowly 

drive tractor off skid.

•      Apply brake to stop trac tor, set park ing brake and place 

motion con trol lever in neutral po si tion.

•      Turn ignition key to "STOP" position.

Continue with the in struc tions that follow.

NOTE: You may now roll or drive your tractor off the skid. 
Follow the appropriate instruction below to remove the 
tractor from the skid.

2466

02464

Adjust seat before tightening adjustment knob.
•     Remove adjustment knob and fl at washer securing 

seat to cardboard packing and set aside for assembly 
of seat to tractor.

•         Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•    Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•      Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•      Pivot seat and pan forward and assemble adjustment 

knob and fl at washer loosely. Do not tighten.

•      Lower seat into operating position and sit on seat.
•     Slide seat until a comfortable position is reached 

which allows you to press clutch/brake pedal all the 
way down.

•      Get off seat without moving its ad just ed position.
•      Raise seat and tighten adjustment knob securely.