Husqvarna 917.374456 用户手册

6

TO ASSEMBLE GRASS CATCH ER
1.   Put grass catcher frame into grass bag 

with rigid part of bag on the bottom. 
Make sure the frame handle is outside 
of the bag top.

2.   Slip vinyl bindings over frame.
NOTE:  If vinyl bindings are too stiff, hold 
them in warm water for a few minutes. If 
bag gets wet, let it dry before using.

TO INSTALL ATTACHMENTS 
Your lawn mower was shipped ready to be 
used as a mulcher. To convert mower to 
bagging or discharging, see “TO CON-
 VERT MOWER” in the Operation section 
of this manual.

Frame 

handle

Frame 

opening

Vinyl 
bindings

MOWING 

POSITION

Lower handle

LIFT 
UP

Operator 
presence 
control bar

Upper 

handle

LIFT 

UP

Handle 

knob

Read these instructions and this man u al in its entirety before you attempt to assemble 
or operate your new lawn mower. 
IMPORTANT:  This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been as sem bled at the factory with the ex cep tion of those 
parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., 
necessary to com plete the as sem bly have been placed in the parts bag. To ensure safe 
and proper operation of your lawn mow er, all parts and hard ware you assemble must be 
tightened se cure ly. Use the correct tools as necessary to ensure proper tightness.

Handle 
bracket

Handle pin

SQUEEZE

1.   Remove loose parts included with 

mower.

2.   Cut down two end corners of carton 

and lay end panel down fl at.

3.   Remove all packing materials ex cept 

padding be tween upper and lower 
handle and padding holding operator 
presence control bar to upper handle.

4.   Roll lawn mower out of carton and 

check carton thorougly for ad di tion al 
loose parts. 

TO UNFOLD HANDLE
IMPORTANT:  Unfold handle carefully so 
as not to pinch or damage con trol cables. 
1.   Raise lower handle section to operat-

ing position and squeeze the bottom 
ends of lower handle towards each 
other until the pin in handle can be 
inserted into one of the three height 
adjustment holes.

2.   Remove protective padding, raise up-

per handle sec tion into place on lower 
handle and tighten both handle knobs.

3.   Remove any packing material from 

around control bar.

Your lawn mower handle can be adjusted 
for your mowing comfort. Refer to “AD-
 JUST HANDLE” in the Service and Adjust-
ments section of this manual.

43