Husqvarna 5521CM 用户手册

下载
页码 20
12
OIL FILLER CAP/DIPSTICK
LOWER 
LIMIT
UPPER 
LIMIT
AIR FILTER
Your engine will not run properly and may be damaged 
by using a dirty air fi lter. Replace the air fi lter every 100 
hours of operation or every season, whichever occurs fi rst.  
Ser vice air cleaner more often under dusty conditions.  See 
the main te nance section of your engine manual.
MUFFLER
Inspect and replace corroded muffl er as it could create a 
fi re hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of each mowing season 
or after every 100 hours of operation, whichever occurs 
fi rst.  Spark plug type and gap setting are shown in the 
“PROD UCT SPEC I FI CA TIONS” section of this manual.
CLEANING
IMPORTANT:  FOR BEST PERFORMANCE, KEEP MOWER 
HOUSING FREE OF BUILT-UP GRASS AND TRASH.  CLEAN 
THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.
CAUTION:  Disconnect spark plug wire 
from spark plug and place wire where it 
cannot come in contact with spark plug.
•      Clean the underside of your lawn mower by scraping 
to remove build-up of grass and trash.
•         Clean engine often to keep trash from accumulating.  A 
clogged engine runs hotter and shortens engine life.
•      Keep fi nished surfaces and wheels free of all gasoline, 
oil, etc.
•      We do not recommend using a garden hose to clean 
lawn mower unless the electrical system, muffl er, air 
fi lter and carburetor are covered to keep water out.  
Water in engine can result in shortened engine life.
MAINTENANCE
FIG. 12
TO CHANGE ENGINE OIL (See Fig. 12)
NOTE:  Before tipping lawn mower to drain oil, drain fuel 
tank by running engine until fuel tank is empty.
1.    Disconnect spark plug wire from spark plug and place 
wire where it cannot come in contact with spark plug.
2.    Remove engine oil cap; lay aside on a clean surface.
3.    Tip lawn mower on its side as shown and drain oil into 
a suitable container. Rock lawn mower back and forth 
to remove any oil trapped inside of engine.
4.   Wipe off any spilled oil from lawn mower or side of 
engine.
5.   Fill engine with oil.  (See “ADD OIL” in the Operation 
section of this manual).
6.    Reconnect spark plug wire to spark plug.