Husqvarna M-ZT 61 /966793003 用户手册

11

OPERATION

•  Follow the mower operation instructions in you 

mower operator manual.

•  When operating the grass catcher on a lawn 

where grass and leaf bagging equipment has 
not been used, thatch and debris that has 
accumulated for long periods of time is picked 
up. The amount collected and the total time of 
operation may be greater than experienced with 
regular use of the grass catcher.

•  Always run throttle at full speed when bagging.
•  Select a speed low enough to give good mower 

cutting performance, good quality cut and good 
bagging performance.
NOTE: It may be necessary to overlap width of 
cut to suit conditions.

•  If grass is extremely tall, it should be mowed 

twice. The first time relatively high, the second 
time to desired height.

•  Use left hand side of mower for trimming.
•  Plastic trash bags (3.0 mil, 30 gallon) can be 

inserted inside grass catcher containers for ease 
of debris disposal. To remove the plastic trash 
bags when full:

  a.  Disengage blades, shift into neutral, engage 

the parking brake and stop the engine.

  b.  Unlatch and raise cover.
  c.  Remove one container at a time by grasping 

container handles and pulling toward the rear, 
off of the tube rails.

  d.  With the container resting on the ground, close 

and secure the top of the plastic lawn bag.

  e.  Tip the container on its side and slide the filled 

bag from the container.

  f. 

Install a new plastic lawn bag with the edges 
of the bag draped over upper lip of the 
Container.

  g.  Repeat for other containers.
  h.  Reinstall containers making sure center 

containers overlap at center supports.

  i. 

Close cover and secure latches over center 
support tubes.

•  Avoid cutting wet grass or in the morning while the 

dew is still heavy. Grass clippings collected under 
these conditions tend to be sticky and adhere to 
the walls of the flow path causing clogging.

•  If the grass catcher fails to pick up cut grass 

or leaves, it is an indication that clogging has 
occurred in the system or that the grass catcher 
containers are full.
a. Disengage blades, place motion control levers 

in neutral position.

 

-  Unlatch and raise cover.

 

-  Slide out containers and dispose of 

clippings.

 

-  Replace containers, close cover, and latch.

b. Unlatch chutes and check for clogging.

 

-  Remove all debris in chute.

 

-  Reassemble and latch chutes.

Always observe safety rules when performing any 
maintenance. Before each use check for loose 
fasteners. Clean unit thoroughly after each use.

For best results mower blades must be kept sharp. 
Replace bent or damaged blades.
See BLADE CARE instructions in the mower operator 
manual.

When grass catcher is to be stored for a period of 
time, clean it thoroughly, remove all dirt, grass, leaves, 
etc. Store in a clean, dry place.