Husqvarna M-ZT 61 /966793003 用户手册

5

ASSEMBLY

1.  Remove the discharge chute from the deck 

by removing the side hardware from the chute 
bracket. Retain the hardware for reuse if the 
collection system is removed.

2.  Lower deck to the lowest cutting position.
3.  Remove the right hand (discharge side) belt cover 

from the deck.

4.  Relieve the tension from the deck belt and remove 

the belt from the center deck pulley. 
(See Operator Manual if necessary)

5.  Remove the nut securing the right hand deck 

pulley to the spindle.

6.  Install drive pulley included in collection system 

kit on top of the current deck pulley.

7.  Reinstall the nut on the spindle and torque to 55-

75 ft/lbs.

8.  Reinstall the deck belt.

1.  Place blower assembly on secure table or stable 

surface.

2.  Remove the bolts securing the rear mount 

bracket.

3.  Using the hacksaw, trim the blower housing along 

the recessed grooves.

4.  Reinstall the rear mount bracket with previously 

removed bolts.

Mount Bracket 
Rear

Trim Line

Belt Cover

Discharge 
Chute
Hardware

Drive Pulley

Outer Pulley Cover

Pin

1.  Position blower over the discharge tabs on the 

deck and set blower onto the deck.

2.  Install the front mount bracket to the deck with the 

pin and hairpin cotter supplied with the kit.