Husqvarna 7021RB 用户手册

Read these instructions and this man u al in its entirety before you attempt to assemble or operate your new lawn mow er. 
IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been as sem bled at the factory with the ex cep tion of those parts left unassembled for shipping 

purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sem bly have been placed in the parts 

bag. To ensure safe and proper operation of your lawn mow er, all parts and hard ware you assemble must be tightened 

se cure ly. Use the correct tools as nec es sary to ensure proper tightness.

1.  Put grass catcher frame into grass bag with rigid part 

of bag on the bottom. Make sure the frame handle is 

outside of the bag top.

2.  Slip vinyl bindings over frame.
NOTE:  If vinyl bindings are too stiff, hold them in warm 

water for a few minutes. If bag gets wet, let it dry before 

using.

Your lawn mower was shipped ready to be used as a 

mulcher.  To convert mower to bagging or discharging, 

see “TO CON VERT MOWER” in the Operation section of 

this man u al.

1.  Remove loose parts included with mower.

2.  Cut down two end corners of  car ton and lay end panel 

down flat.

3.  Remove all packing materials ex cept padding be tween 

upper and lower handle and padding holding operator 

presence control bar to up per handle.

4.  Roll lawn mower out of carton and check carton thor-

ougly for ad di tion al loose parts.

IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS NOT 

TO PINCH OR DAMAGE CONTROL CABLES. 
1.  Raise lower handle section to operating position and 

squeeze the bottom ends of  lower handle towards 

each other until the pin in handle can be inserted into 

one of the three height adjustment holes.

2.  Remove protective padding, raise upper handle section 

into place on lower handle and tighten both handle 

knobs.

3.  Remove any packing material from around control 

bar.

Your handles may be adjusted for your mowing comfort. 

Refer to “ADJUST HANDLE” in the Service and Adjustments 

section of this manual.