Husqvarna 5521RSX 用户手册

The handle on your lawn mower has three (3) height posi-
tions - adjust to height that suits you.

•         Squeeze the bottom ends of lower handle towards each 

other until the pin in handle can be inserted into one 
of the three height adjustment holes.

Maintenance, re pair, or re place ment of the emission con-
 trol de vic es and sys tems, which are be ing done at the 
cus tom ers expense, may be performed by any non-road 
engine repair es tab lish ment or individual. Warranty repairs 
must be performed by an authorized engine man u fac tur er's 
service outlet.

Your engine speed has been factory set.  Do not attempt to 
increase engine speed or it may  result in personal injury.  If 
you believe that the engine is running too fast or too slow, 
take your lawn mower to an authorized service center for 
repair and adjustment.

Your carburetor is not adjustable.  If your engine does not 
operate properly due to suspected carburetor problems, 
take your lawn mower to an authorized service center for 
repair and/or adjustment.

IMPORTANT:  NEVER TAMPER WITH THE ENGINE GOVERNOR, 
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.  
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH 
SPEED SETTING CAN BE DANGEROUS.  IF YOU THINK THE 
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, 
CONTACT YOUR NEAREST AUTHORIZED SER VICE CEN TER, 
WHICH HAS PROPER EQUIP MENT AND EXPERIENCE TO 
MAKE ANY NEC ES SARY ADJUSTMENTS. 

Immediately prepare your mower for storage at the end of the season or if the unit will not be used for 30 days or more. 

You can fold your lawn mower handle for stor age.

1.    Loosen the two (2) handle knobs on sides of the upper 

handle and allow handle to fold down to the rear.

2.      Squeeze the bottom ends of lower handle toward each 

other until pins in handle clear the brackets and pivot 
entire han dle assembly forward and allow it to rest on 
mower.

•         When setting up your handle from the storage position, 

the lower handle will require manually locking into the 
mowing position.

IMPORTANT:  WHEN FOLDING THE HANDLE FOR STORAGE 
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS 
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES. 

When lawn mower is to be stored for a period of time, clean 
it thoroughly, remove all dirt, grease, leaves, etc.  Store in 
a clean, dry area.

1.    Clean  entire  lawn  mower  (See  “CLEANING”  in  the 

Maintenance section of this manual).

2.    Lubricate as shown in the Maintenance section of this 

manual.

3.      Be sure that all nuts, bolts, screws, and pins are securely 

fastened.  Inspect  moving parts for damage, breakage 
and wear.  Replace if necessary.

4.   Touch up all rusted or chipped paint surfaces; sand 

lightly before painting.