Husqvarna MZ5225ZT / 966690501 用户手册

下载
页码 64
CONTROls
23
IMPORTANT INFORMATION
Experience indicates that alcohol blended 
fuels (called gasohol, ethanol or methanol) 
can attract moisture which leads to separation 
and formation of acids during storage. Acidic 
gas can damage the fuel system of an engine 
while in storage. To avoid engine problems, 
the fuel system should be emptied before 
storage of 30 days or longer. Drain the gas 
tank, start the engine and let it run until the 
fuel lines and carburetor are empty. Use fresh 
fuel the next season. See Storage Instructions
 
for additional information. Never use engine 
or carburetor cleaners in the fuel tank or 
permanent damage may occur.
Fuel Tank
Read the safety instructions before refueling. the 
capacity for the tank is 5 gallons (19 liters).
Regularly check the gas cap gasket for damage and 
keep the cap properly tightened.
the engine will run on a minimum of 87-octane 
unleaded gasoline (no oil mix). environmentally 
adapted alkylate gasoline can be used. See technical 
Data concerning ethanol fuel. Methanol fuel is not 
allowed. Do not use e85 alcohol based fuel. Damage 
to the engine and components may occur.
When operating in temperatures below 32° F. (0° C.), 
use fresh, clean winter grade gasoline to help insure 
good cold weather starting.
WARNING!
Gasoline is highly flammable. 
Observe caution and fill the tank 
outdoors (see the safety instruction).
WARNING!
The engine and the exhaust system 
become very hot during operation.
Risk for burns if touched.
Allow engine and exhaust system to 
cool at least two (2) minutes before 
refueling
WARNING!
Fill to bottom of filler neck. Do not 
overfill. Wipe off any spilled oil 
or fuel. Do not store, spill or use 
gasoline near an open flame.
8065-007
Gasoline fuel tank
Hydro Release Levers
transaxle bypass linkages must be engaged when 
pushing or pulling the mower. the release levers are 
located on each side of the rear of the unit below 
the rear engine plate. See Manual Transport in the 
Operation section.
8065-061
Right side, hydro release lever