Husqvarna MZ5225BF / 968999720 用户手册
English
-48
MAINTENANCE
Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they
Anti-scalp rollers are properly adjusted when they
are just slightly off of the ground when the deck is at
the desired cutting height in the operating position.
Anti-scalp rollers then keep the deck in the proper
position to help prevent scalping in most terrain
conditions.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower
Adjust anti-scalp rollers with the mower
on a flat level surface.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used
The anti-scalp rollers must not be used
for gauge wheels or the roller and deck
may be damaged.
CZ-9
Anti-scalp rollers
The
anti-scalp rollers can be set in three positions:
•
Upper position 1½ to 3" (38 to 76 mm) grass.
•
Middle position 3" to 4½" (76 to 114 mm) grass.
•
lower position 4½" to 6" (114 to 152 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
Confirm measurements once again. Blade
4.
tips should be level in a side-to-side manner.
In the rear, blade tips should be level to
1
/
8
"
higher than side-to-side measurement. In the
front, blade tips should be level to
1
/
8
" lower
than side-to-side measurement.
NOTE: This will place the mower deck in a base
measurement position. Additional adjustment may be
required to achieve desired cut for the type of grass or
conditions being mowed.