Husqvarna MZ61 用户手册
1
2
34
OPERATION
Moving Machine By Hand
8058-059
1. IZT locked into the bypass position
2. Linkage lever, engaged
Right side, IZT linkage
2. Linkage lever, engaged
Right side, IZT linkage
When pushing or pulling the mower, engage the IZT
(Integrated Zeroturn Transaxle) bypass linkages. The
release levers are located on each side of the rear of
the unit below the rear engine plate.
1. Raise the deck to the highest (transport) position.
2. Pull the release levers up and out of the keyhole
(Integrated Zeroturn Transaxle) bypass linkages. The
release levers are located on each side of the rear of
the unit below the rear engine plate.
1. Raise the deck to the highest (transport) position.
2. Pull the release levers up and out of the keyhole
slots. Release the levers with the head outside the
bracket and held into the bypass setting.
bracket and held into the bypass setting.
3. To reengage the IZTs to drive, reverse the above
procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNING! Bypass linkages are located
close to the muffler. To prevent burns, the
engine should be shut off and allowed to cool
before the bypass linkage levers are handled.
engine should be shut off and allowed to cool
before the bypass linkage levers are handled.
WARNING! Use extreme caution when
loading the machine into a truck or trailer using
ramps. There is the possibility of serious injury
or death if the machine falls off the ramps.
ramps. There is the possibility of serious injury
or death if the machine falls off the ramps.
WARNING! No adjustments or
maintenance should be carried out unless:
• the engine stopped
• the ignition key removed
• the parking brake activated
• the engine stopped
• the ignition key removed
• the parking brake activated