Husqvarna LGTH2454 用户手册

If tractor requires more than five (5) feet to stop at highest 

speed in high est gear on a level, dry concrete or paved 

surface, then brake must be serviced.
You may also check brake by:
• 

Park tractor on a level, dry concrete or paved surface, 

depress brake pedal all the way down and engage 

parking brake.

•  Disengage transmission by placing freewheel control 

in “transmission disengaged” position. Pull freewheel 

control out and into the slot and release so it is held in 

the disengaged position.

The rear wheels must lock and skid when you try to manu-

ally push the tractor forward. If the rear wheels rotate, 

then the brake needs to be serviced. Contact a qualified 

service center.

Park the tractor on level surface. En gage parking brake. 

For as sis tance, there is a belt installation guide decal on 

bottom side of left footrest.
BELT REMOVAL -
1.  Remove mower (See “TO REMOVE MOWER” section 

in this manual).

NOTE: Observe entire motion drive belt and position of all 

belt guides and keepers.

2.  Disconnect clutch wire harness (A).
3.  Remove anti-rotation link (B) on right side of tractor.
4.  Remove belt from stationary idler (C) and clutching idler (D).
5.  Remove belt from centerspan idler (E).
6.  Pull belt slack toward rear of trac tor. Carefully remove 

belt up wards from trans mis sion input pulley and over 

cooling fan blades (F).

7.  Remove belt downward from engine pulley and around 

electric clutch (G).

8- Slide belt toward rear of tractor, off the steering plate 

(H) and remove from tractor.

BELT INSTALLATION -
1.  Install new belt from tractor rear to front, over the steer-

ing plate (H) and above clutch brake pedal shaft (J).

2. Pull belt toward front of tractor and roll belt around 

electric clutch and onto engine pulley (G).

3.  Pull belt toward rear of tractor. Carefully work belt down 

around transmission cooling fan and onto the input pul-

ley (F). Be sure belt is inside the belt keeper.

4.  Install belt on centerspan idler (E).
5. Install belt through stationary idler (C) and clutch ing 

idler (D).

6.  Reinstall anti-rotation link (B) on right side of tractor. 

Tighten securely.

electric

02953

7.  Reconnect clutch harness (A).
8-  Make sure belt is in all pulley grooves and in side all belt 

guides and keep ers.

9.  Install mower (See “TO INSTALL MOWER” section in 

this manual).

The motion control lever has been pre set at the factory 

and adjustment should not be necessary.
• 

Loosen adjustment bolt in front of the right rear wheel, 

and lightly tighten.

• 

Start engine and move motion control lever until tractor 

does not move forward or backward.

•  Hold motion control lever in that position and turn engine 

off.

• 

While holding motion control lever in place, loosen the 

adjustment bolt.

• 

Move motion control lever to the neutral (lock gate) position.

•  Tighten adjustment bolt securely.
NOTE:  If additional clearance is needed to get to ad just ment 

bolt, move mower deck height to the lowest position.
After above adjustment is made, if the tractor still creeps 

forward or backward while motion control lever is in neutral 

position, follow these steps:
•  Loosen the adjustment bolt.
• 

Move the motion control lever 1/4"  to 1/2"  in the direc-

tion it is trying to creep.

•  Tighten adjustment bolt securely.
•  Start engine and test.
• 

If tractor still creeps, repeat above steps until satisfied.