Husqvarna LC 19A 用户手册

English

 – 15

Engine does not start

Throttle control lever not in correct starting 
position

Move throttle lever to FAST or START position

Faulty spark plug connections or interchanged 
cables

Connect ignition lead to spark plug

There is no fuel in the fuel tank

Fill tank with clean, fresh unleaded petrol

Dirt in the carburettor or fuel line

Clean carburettor and/or fuel line

Spark plug defective

Clean, adjust gap or replace

Engine flooded

Crank engine with throttle in FAST position

Engine does not stop

Stop switch/mechanism malfunction

Disconnect spark plug ignition lead and check 
the machine at an autorized dealer.

Engine runs erratic

Unit running in START position

Move throttle lever to FAST position

Spark plug ignition lead loose

Connect and tighten spark plug ignition lead

Blocked fuel line or stale fuel

Clean fuel line; fill tank with clean fresh unleaded 
petrol

Vent in gas cap plugged

Clean vent

Water or dirt in fuel system

Drain fuel tank. Refill with fresh fuel

Dirty air cleaner

Clean air cleaner

Carburettor out of adjustment

Adjust carburettor

Engine overheats

Engine oil level low

Fill crankcase with recommended oil

Air flow restricted

Remove blower housing and clean

Carburettor not adjusted properly

Adjust carburettor

Occasional skip (hesitates) 
at high speed

Spark plug gap too close

Adjust gap to 0.50 mm

Idles poorly

Spark plug fouled, faulty or gap too wide

Reset gap to 0.50 mm or replace spark plug

Carburettor improperly adjusted

Adjust carburettor

Dirty air filter

Clean air cleaner

Excessive vibration

Cutting blade loose or unbalanced

Tighten blade and adapter, Balance blade

Bent cutting blade

Replace blade

Mower will not mulch grass Engine speed too low

Set throttle between 3/4 and full throttle

Wet grass

Do not mow when grass is wet, wait until later to 
cut

Excessively high grass

Mow once at high cutting height, then mow again 
at desired height or make a narrower cutting 
strip, e.g. 1/2 width

Dull blade

Sharpen or replace blade

Uneven cut

Wheels not positioned correctly

Place all four wheels in same height position

Dull blade

Sharpen or replace blade