Husqvarna LR122 用户手册

下载
页码 48
10
OPERATION
TO OPERATE MOWER (See Figs. 11 and 12)
Your tractor  is equipped with an operator presence sensing
switch.  Any attempt by the operator to leave the seat with
the engine running and the attachment clutch engaged will
shut off the engine.
Select desired height of cut.
Start mower blades by engaging attachment clutch
control.
TO STOP MOWER BLADES - disengage attachment
clutch control.
CAUTION:  Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the dis-
charge guard in place.
ATTACHMENT
CLUTCH LEVER
“ENGAGED”
POSITION
ATTACHMENT
CLUTCH LEVER
“DISENGAGED”
POSITION
ADD GASOLINE
Fill fuel tank.  Use fresh, clean, regular unleaded
gasoline with a minimum of 87 octane.  (Use of  leaded
gasoline will increase carbon and lead oxide deposits
and reduce valve life).  Do not mix oil with gasoline.
Purchase fuel in quantities that can be used within 30
days to assure fuel freshness.
IMPORTANT:  WHEN OPERATING IN TEMPERATURES
BELOW 32
°
F(0
°
C), USE FRESH, CLEAN WINTER GRADE
GASOLINE TO HELP INSURE GOOD COLD WEATHER
STARTING.
WARNING:  Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or methanol) can
attract moisture which leads to separation and formation of
acids during storage.  Acidic gas can damage the fuel
system of an engine while in storage.  To avoid engine
problems, the fuel system should be emptied before stor-
age of 30 days or longer.  Drain the gas tank, start the
engine and let it run until the fuel lines and carburetor are
empty.  Use fresh fuel next season.  See Storage Instruc-
tions for additional information.  Never use engine or
carburetor cleaner products in the fuel tank or permanent
damage may occur.
CAUTION:  Fill to bottom of gas tank
filler neck.  Do not overfill.  Wipe off any
spilled oil or fuel.  Do not store, spill or
use gasoline near an open flame.
TO TRANSPORT
Raise attachment lift to highest position with attach-
ment lift control.
When pushing or towing your tractor, be sure gearshift
lever is in neutral (N) position.
Do not push or tow tractor at more than five (5) MPH.
NOTE:  To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood is closed and
secured to tractor.  Use an appropriate means of tying hood
to tractor (rope, cord, etc.).
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
The engine in your tractor  has been shipped, from the
factory, already filled with summer weight oil.
Check engine oil with tractor on level ground. See
engine manual for further instructions.
For cold weather operation you should change oil for
easier starting (See engine manual).
To change engine oil, see the Customer Responsibili-
ties section in this manual.
FIG. 12
FIG. 11
6
3 2
1
ATTACHEMENT
LIFT LEVER
ATTACHMENT
HEIGHT
ADJUSTMENT
KNOB
TO OPERATE ON HILLS
CAUTION:  Do not drive up or down
hills with slopes greater than 15
°
 and
do not drive across any slope.
Choose the slowest speed
 
 before starting up or down
hills.
Avoid stopping or changing speed on hills.
If slowing is necessary, move throttle control lever to
slower position.
The average lawn should be cut to approximately 2-1/2
inches during the cool season and to over 3 inches
during hot months.  For healthier and better looking
lawns, mow often and after moderate growth.
For best cutting performance, grass over 6 inches in
height should be mowed twice.  Make the first cut
relatively high; the second to desired height.•
The average lawn should be cut to approximately
2-1/2 inches during the cool season and to over 3
inches during hot months.  For healthier and better
looking lawns, mow often and after moderate growth.
For best cutting performance, grass over 6 inches in
height should be mowed twice.  Make the first cut
relatively high; the second to desired height.
If stopping is absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
Move gearshift  lever to 1st gear and be sure you have
allowed room for tractor to roll slightly as you restart
movement.
To restart movement, slowly release parking brake and
clutch/brake pedal.
Make all turns slowly.