Husqvarna 96143004400 用户手册

Read these instructions and this man u al in its entirety before you attempt to assemble or operate your new lawn mow er. 
IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been as sem bled at the factory with the ex cep tion of those parts left unassembled for shipping 

purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sem bly have been placed in the parts 

bag. To ensure safe and proper operation of your lawn mow er, all parts and hard ware you assemble must be tightened 

se cure ly. Use the correct tools as nec es sary to ensure proper tightness.

1.  Put grass catcher frame into grass bag with rigid part 

of bag on the bottom. Make sure the frame handle is 

outside of the bag top.

2.  Slip vinyl bindings over frame.
NOTE:  If vinyl bindings are too stiff, hold them in warm water 

for a few minutes. If bag gets wet, let it dry before using.

Your lawn mower was shipped ready to be used as a 

mulcher.  To convert mower to bagging or discharging, 

see “TO CON VERT MOWER” in the Operation section of 

this man u al.

NOTE:  Your battery must be charged before you can start 

your lawn mower.
1. Con 

nect battery charger con nec tor (male) to harness 

con nec tor (fe male).

2.  Plug battery charger into 110 volt A.C. outlet.
3.  Leave battery charger connected for 24 hours before 

starting your engine for the first time.

4.  After charging, disconnect harness connector (female) 

from bat tery charger connector (male).

Connect your battery charger to charge battery as required.

IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR 

BATTERY.  AT THE END OF THE MOWING SEASON THE BATTERY 

SHOULD BE CHARGED FOR 48 HOURS TO PROTECT THE 

BATTERY DURING WINTER STORAGE.

LIFT 

UP

LIFT UP

MOWING 

PO SI TION

1.  Remove loose parts included with mower.
2.  Cut down two end corners of  car ton and lay end panel 

down flat.

3.  Remove all packing materials ex cept padding be tween 

upper and lower handle and padding holding operator 

presence control bar to up per handle.

4.  Roll lawn mower out of carton and check carton thor-

ougly for ad di tion al loose parts.

IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS NOT 

TO PINCH OR DAMAGE CON TROL CABLES. 
1.  Raise handles until lower handle section locks into 

place in mowing position.

2.  Remove protective padding, raise upper handle sec tion 

into place on lower handle and tighten both handle knobs.

3.  Remove handle padding holding operator pres ence 

control bar to upper handle.

Your handles may be adjusted for your mowing comfort. 

Refer to “ADJUST HANDLE” in the Service and Ad just ments 

sec tion of this man u al.