Husqvarna LTH1536 用户手册

01156

01267

01553

00598

“A”

“A”

•      Lower lift lever to its lowest po si tion.
•     Connect front links to mower deck and secure with 

retainer springs.

•     Connect suspension arms to rear deck brackets and 

secure with retainer springs.

•     Connect anti-swaybar to chassis bracket and secure 

with retainer spring.

•         Push clutch cable housing guide into bracket, slide col-

lar onto guide and secure with large retainer spring.

•      Place fl at washer and clutch spring on idler pulley bolt 

and secure with small retainer spring.

•      Install belt onto engine pulley.

Adjust the mower while tractor is parked on level ground 
or driveway.  Make sure tires are properly infl ated (See 
“PROD UCT SPECIFICATIONS” section of this manual).   If 
tires are over or underinfl ated, you will not properly adjust 
your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16)
•      Raise mower to its highest position.
•         At the midpoint of both sides of mower, measure height 

from bot tom edge of mower to ground.   Distance “A” 
on both sides of mower should be the same or within 
1/4" of each other.

•     If adjustment is necessary, make adjustment on one 

side of mower only.

•      To raise one side of mower, tighten lift link ad just ment 

nut on that side.

•      To lower one side of mower, loosen lift link ad just ment 

nut on that side.

NOTE:  Three full turns of adjustment nut will change mower 
height about 1/8".
•      Recheck measurements after adjusting.

The mower blade drive belt may be replaced without tools.  
Park the tractor on level surface.  Engage parking brake.  

FRONT-TO-BACK ADJUSTMENT (See Figs.17 and 18) 

IMPORTANT:  DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE 
FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, 
BE SURE TO AD JUST BOTH FRONT LINKS  EQUAL LY  SO 

 

MOWER  WILL STAY LEVEL SIDE-TO-SIDE.      

To obtain the best cutting results, the mower housing 
should be adjusted so that the front is approximately 1/8" 
to 1/2" lower than the rear when the mower is in its high-
est position.

Check adjustment on right side of tractor.  Measure dis tance 
“D” directly in front and behind the mandrel at bottom edge 
of mower housing as shown.
•      Before making any necessary adjustments, check that 

both front links are equal in length.  

•      If links are not equal in length, adjust one link to same 

length as other link.

•     To lower front of mower loosen nut “E” on both front 

links an equal number of turns.

•     When distance “D” is 1/8" to 1/2" lower at front than 

rear, tighten nuts “F” against trunnion on both front 
links.

•     To raise front of mower, loosen nut “F” from trunnion 

on both front links. Tighten nut “E” on both front links 
an equal number of turns.  The two front links must 
remain equal in length.

•         When distance “D” is 1/8" to 1/2" lower at front than rear, 

tighten nut “F” against trunnion on both front links.

•      Recheck side-to-side adjustment.