Husqvarna 965167501 用户手册

34 – English

115 10 82-26 Rev.2 2008-06-03

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm and hook it into the 
notch in the rim of the pulley. Release the recoil spring 
by letting the pulley rotate slowly backwards.

•

Undo the bolt in the centre of the pulley and remove 
the drive disc (A), drive disc spring (B) and the pulley 
(C). Insert and secure a new starter cord in the starter 
pulley. Wind approx. 3 turns of the starter cord on the 
starter pulley. Fit the starter pulley so that the end of 
the recoil spring (D) hooks into the starter pulley. Now 
assemble the drive disc spring, drive disc and the bolt 
in the centre of the pulley. Carry the starter cord 

through the hole in the starter housing and the starter 
handle. Tie a good knot on the starter cord.

•

Hook the starter cord in the notch in the pulley and 
turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned at least a 
further 1/2 turn when the starter cord is pulled all the 
way out.

Stretch the line with the handle. Move your thumb and 
release the line. See the figure below.