Husqvarna 961430099 用户手册

See “TO ADJUST CUTTING HEIGHT” in the Operation 
section of this manual.

The rear defl ector, attached between the rear wheels of 
your mower, is provided to minimize the possibility that 
objects will be thrown out of the rear of the mower into 
the operator's mowing position.  If the defl ector becomes 
damaged, it should be replaced.

1.  Remove screws securing rear baffl e.

2.  Turn lawn mower on its side with air fi lter and car bu re-

 tor up.

3.  Remove rear baffl e from mower.

4.  Disconnect return spring from rear baffl e / rear gearcase 

belt keeper.

5.  Remove blade bolt, lockwasher, hardened washer and 

blade.

6.  Remove debris shield.

7.  Remove gearcase belt keeper.

8.  Remove drive belt.

1.  Place new drive belt on gearcase pulley.

NOTE: Always use factory approved belt to assure proper 
fi t and long life.

2.  Reinstall gearcase belt keeper.  Be sure the new drive 

belt is inside the tabs of the gearcase belt keeper. 

3.  Position the blade adapter on the engine crank shaft. 

Be sure key in adapter and crankshaft keyway are 
aligned; and that the new drive belt is inside the tabs 
of the belt retainer.

4.  Reattach return spring to rear baffl e / rear gearcase 

belt keeper.

5.  Place rear baffl e in mower housing.

6.  Reinstall debris shield.

7.  Reinstall blade.  The recommended tightening torque is 33-

40 ft. lbs.

8.  Return mower to upright po si tion.

9.  Reinstall rear baffl e screws.

The handle on your lawn mower has three (3) height posi-
tions - adjust to height that suits you.

1.  Remove knob and carriage bolt on one side of the 

lower handle.

2.  While holding handle assembly, remove knob and 

car riage bolt from opposite side, align hole in handle 
with desired hole in handle bracket and reassemble 
bolt and knob and tighten securely.

3.  Align opposite side of handle with same positioning 

hole and secure with bolt and knob.