Husqvarna 96143005700 用户手册

Immediately prepare your mower for storage at the end 
of the season or if the unit will not be used for 30 days or 
more. 

When lawn mower is to be stored for a period of time, clean 
it thoroughly, remove all dirt, grease, leaves, etc.  Store in 
a clean, dry area.

1.  Clean entire lawn mower (See “CLEANING” in the 

Maintenance section of this manual).

2.  Lubricate as shown in the Maintenance section of this 

manual.

3.  Be sure that all nuts, bolts, screws, and pins are securely 

fastened.  Inspect  moving parts for damage, breakage 
and wear.  Replace if necessary.

4.  Touch up all rusted or chipped paint surfaces; sand 

lightly before painting.

You can fold your lawn mower handle for stor age.

1.  Loosen the two (2) handle knobs on sides of the upper 

handle and allow handle to fold down to the rear.

2.  Squeeze the bottom ends of lower handle toward each 

other until pins in handle clear the brackets and pivot 
entire han dle assembly forward and allow it to rest on 
mower.

• 

When setting up your handle from the storage position, 
the lower handle will require manually locking into the 
mowing position.

IMPORTANT:  WHEN FOLDING THE HANDLE FOR STORAGE 
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS 
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES. 

IMPORTANT:  IT IS IMPORTANT TO PREVENT GUM DEPOSITS 
FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS 
SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR 
TANK DURING STORAGE.  ALCOHOL BLENDED FUELS 
(CALLED GASOHOL OR USING ETHANOL OR METHANOL) 
CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION 
AND FORMATION OF ACIDS DURING STORAGE.  ACIDIC GAS 
CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN 
STORAGE.

• 

Empty the fuel tank by starting the engine and letting 
it run until the fuel lines and carburetor are empty.

• 

Never use engine or carburetor cleaner products in the 
fuel tank or permanent damage may occur.

• 

Use fresh fuel next season.

NOTE:  Fuel stabilizer is an acceptable alternative in mini-
mizing the formation of fuel gum deposits during stor age.  
Add stabilizer to gasoline in fuel tank or storage container.  
Always follow the mix ratio found on stabilizer container.  
Run engine at least 10 minutes after adding stabilizer to 
allow the stabilizer to reach the carburetor.  Do not empty 
the gas tank and carburetor if using fuel stabilizer.

Drain oil (with engine warm) and replace with clean en-
gine oil.  (See “ENGINE” in the Maintenance section of 
this manual).