Husqvarna RZ3016/966612301 用户手册
CONTROLS
22
Bypass Linkages
Transaxle bypass linkages must be engaged when
pushing or pulling the mower. The release levers are
located on each side of the rear of the unit below the
rear engine plate. See Moving Machine By Hand in
pushing or pulling the mower. The release levers are
located on each side of the rear of the unit below the
rear engine plate. See Moving Machine By Hand in
the Operation section.
8050-018
Set bypass linkages into slots on both sides
Blade Control Lever
To engage the mower blades, slowly lift the lever up
and into the the lock notch.
and into the the lock notch.
8058-074
Mower deck blade control lever in the disengaged position
WARNING!
No adjustments or maintenance to be
carried out unless:
carried out unless:
• the engine stopped
• the ignition key removed
• the parking brake activated
WARNING!
Bypass linkages are located close
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levels are handled.
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levels are handled.