Husqvarna Z 246i 用户手册

When pushing or pulling the mower, engage the EZT bypass 
linkages. The EZT bypass linkages are located on the rear of 
the frame, below the rear engine guard.

1.  Raise the deck into the highest cutting position.
2.  Move the steering / park brake controls inwards to the 

neutral position.

3.  Pull the EZT bypass linkages up and out of the keyhole 

slots. Release the levers with the head outside the frame 
and held in the bypass position.

4.  To reengage the EZT’s to drive, reverse the above 

procedure.

  WARNING!  Use extreme caution when loading the 

machine into a truck or trailer using ramps. There is the 
possibility of serious injury or death if the machine falls off 
the ramps.

  WARNING!  Make no adjustments without:

• 

the engine stopped,

• 

the ignition switch turned off,

• 

the park brake activated

  WARNING!  Bypass linkages are located close to 

the muffler. To prevent burns, the engine should be shut off 
and allowed to cool before the bypass linkage levers are 
handled.

Load the machine into truck or trailer by driving slowly up the 
ramps. DO NOT LIFT! The machine is not intended to be lifted 
by hand.

23

OPERATION