Husqvarna P 520D 用户手册

22 – 

English

Clean the machine directly after use. It is much easier to wash 
off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. 
Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or 
bearings.

Do not rinse hot surfaces such as the engine and exhaust 
system.

It is recommended that you start the engine and run the 
mower for a short period after cleaning, so that any remaining 
water is blown off.

Lubricate the machine if necessary after cleaning. Carry out 
extra lubrication when the bearings have been exposed to a 
degreaser or a water jet.

There is a major risk of water penetrating into bearings and 
electrical connections. Corrosion attack can result, which will 
lead to running problems. Cleaning additives generally 
aggravate the damage.

Loosen the rubber straps on the side of the cover and lift up 
the engine cover.

If necessary the engine cover can be lifted off by removing the 
bolts.

Loosen the screws holding the side cover and remove it.

A service panel is fitted in the base plate.

Loosen the screws and lift off the panel.

Loosen the screws and remove the transmission cover.

Make sure the radiator grille is free of leaves, grass and dirt.

Open the engine cover.

If necessary, remove the engine cover.

Clean the radiator with compressed air. Use compressed air 
blown from the engine compartment through the cell package 
and back.

Avoid using a high pressure washer or a steam cleaner.