Husqvarna 16C 用户手册

English

 – 17

With a warm engine:

6

Move the throttle in between positions 1 and 2.

7

Turn the ignition key to the start position.

8

When the engine starts release the ignition key 
immediately back to neutral position.

9

Push the choke lever gradually forward when the engine 
has started. Let the engine run at moderate speed or half 
throttle for 3-5 minutes before subjecting it to heavy load.

10 Set the required engine speed with the throttle control.

If the battery is too weak to start the engine, it should be 
recharged.

When jump leads are used for emergency starting, follow the 
procedure below:

•

Connect each end of the red cable to the POSITIVE pole 
(+) on each battery, exercise care not to short circuit any 
of the ends against the chassis.

Connect one end of the black cable to the NEGATIVE pole 
(-) on the fully charged battery.

•

Connect the other end of the black cable to a good 
CHASSIS EARTH, away from the fuel tank and the 
battery.

•

The BLACK cable is removed from the chassis and then 
the fully charged battery.

•

Finally the RED cable from both batteries.

If the engine does not start, wait about 15 seconds before 
trying again. If the engine does not start wait about 1 minute 
before trying again.