Husqvarna 15T 用户手册
English
– 15
Driving
Before starting
•
Read the safety instructions and information concerning
the placement of controls and functions before starting.
the placement of controls and functions before starting.
•
Perform daily maintenance before starting as set out in
the Maintenance schedule.
the Maintenance schedule.
Start the engine
1
Make sure that the clutch control is depressed. Rider 15T
AWD and Rider 15Ts AWD have one control for the front
axle and one control for the rear axle.
AWD and Rider 15Ts AWD have one control for the front
axle and one control for the rear axle.
2
Lift up the cutting unit by pulling the lever backwards to
locked position (transport position) and apply the parking
brake. The engine can not be started if the parking brake
is not pressed down.
locked position (transport position) and apply the parking
brake. The engine can not be started if the parking brake
is not pressed down.
3
Move the throttle control to the middle position.
4
If the engine is cold move the choke lever backwards to its
end position.
end position.
5
Turn the ignition key to the start position.
6
When the engine starts release the ignition key
immediately back to neutral position.
immediately back to neutral position.
7
Push the choke lever gradually forward when the engine
has started.
has started.
IMPORTANT INFORMATION
The air intake grille in the engine cover behind the driver’s
seat must not be blocked by, for example, clothing, leaves,
grass or dirt. Impaired cooling of the engine.
seat must not be blocked by, for example, clothing, leaves,
grass or dirt. Impaired cooling of the engine.
Risk of major engine damage.
IMPORTANT INFORMATION
Do not run the starter for more than about 5 seconds at a
time. If the engine does not start, wait about 15 seconds
before trying again.
time. If the engine does not start, wait about 15 seconds
before trying again.