Husqvarna 15V2 AWD 用户手册

English

 – 17

4

Press in the lock button on the lifting lever and lower the 
cutting unit.

•

Localise and mark stones and other fixed objects to avoid 
collision.

•

Start with a high cutting height and reduce down until the 
required mowing results are obtained.

•

The mowing results are best with a high engine speed 
(fast rotating blades) and low driving speed (slow moving 
machine). If the grass is not too high and thick, the driving 
speed can be increased without noticeably depreciating 
the mowing result.

•

The best lawns are achieved if the grass is cut often. 
Mowing becomes more uniform and the grass cuttings 
become more evenly distributed over the surface. The 
total time consumption is not greater since it is possible to 
select a higher driving speed without inferior mowing 
results.

•

Avoid mowing a wet lawn. The mowing results are inferior 
since the wheels sink down into the soft lawn.

•

Hose down the cutting unit with water underneath each 
time it is used. The cutting unit should then be put in the 
service position.

•

When the BioClip function is used, it is very important that 
the mowing interval is not too long.

Preferably allow the engine to idle for a minute to obtain 
normal working temperature before stopping it if it has been 
working hard. Avoid idling the engine for long periods, as 
there is a risk of carbon build-up on the spark plugs.

1

Lift up the cutting unit by pulling the lever backwards to its 
locked position.

2

Move the throttle control to the MIN. position. Turn the 
ignition key to the ”STOP”.

3

When the Rider is at a standstill, press down the parking 
brake and push in the locking button.

The life span of the drive belts is increased significantly if 
the engine runs at a low speed when the blades are 
engaged. Therefore apply full throttle first when the cutting 
unit has been moved to the mowing position.

°°°°.... Mow