Husqvarna 15V2 AWD 用户手册

22 – 

English

1

Loosen the clamping screw for the cable’s outer casing 
and move the throttle to the full throttle position.

2

Check that the throttle wire is attached to the correct hole 
in the lower lever, see diagram.

3

Pull the throttle wire casing to the far left and tighten the 
clamping screw.

If the engine is producing black smoke or is difficult to start 
then the choke wire (upper wire) may be incorrectly adjusted.

If doubts arise, contact your service representative.

If it is necessary to adjust the choke, proceed as follows:

1

Release the clamping screw that secures the wire casing 
and set the choke control to maximum choke.

2

Check that the throttle wire is attached to the upper lever, 
see diagram.

3

Pull the choke wire casing to the far right and tighten the 
clamping screw.

Replace the fuel filter every 100 running hours (once per 
season) or more frequently if it is clogged.

Replace the filter as follows:

1

Open the engine cover.

2

Move the hose clips away from the filter. Use a pair of flat 
pliers.

3

Pull off the filter from the hose ends.

4

Press the new filter into the ends of the hoses. If 
necessary apply liquid detergent to the ends of the filter to 
facilitate connection.

5

Push the hose clips back on the filter and tighten.

If the engine seems to lack power or does not run smoothly 
this may be because the air filter is clogged. It is therefore 
important to replace the air filter at regular intervals (see 
Maintenance/Maintenance Schedule for the correct service 
interval).

Replace the air filter as follows:

1

Remove the air filter unit by pressing on the catches with 
your fingers.

2

Remove the pre-filter and paper filter from the air filter 
unit.

3

Clean the pre-filter by washing it with water and detergent.

4

Dry the pre-filter properly.

5

Tap the paper filter against a hard surface to shake off the 
dust.

Never run the engine without the air filter fitted.

The filters must not be oiled. They must be fitted dry.