Husqvarna 175 AWD 用户手册

English

 – 15

•

Read the safety instructions and information concerning 
the placement of controls and functions before starting.

•

Perform daily maintenance before starting as set out in 
the Maintenance schedule.

1

Make sure that the clutch control is depressed. Rider 175 
AWD has one control for the front axle and one control for 
the rear axle.

2

Lift up the cutting unit by pulling the lever backwards to 
locked position (transport position) and apply the parking 
brake.

Rider 175 AWD The engine can not be started if the 
parking brake is not pressed down.

Starting a cold engine

3

Move the throttle to position 3 (choke position). In this 
position the engine is fed with a richer mixture, which 
means the engine is easier to start.

Starting a warm engine

Move the throttle in between positions 1 and 2.

4

Turn the ignition key to the start position.

5

When the engine starts release the ignition key 
immediately back to neutral position.

6

Push the throttle control to full throttle position. Let the 
engine run at moderate speed or half throttle for 3-5 
minutes before subjecting it to heavy load.

7

Set the required engine speed with the throttle control.

The air intake grille in the engine cover behind the driver’s 
seat must not be blocked by, for example, clothing, leaves, 
grass or dirt. Impaired cooling of the engine.

Risk of major engine damage.

Do not run the starter for more than about 5 seconds at a 
time. If the engine does not start, wait about 15 seconds 
before trying again.