Husqvarna 15Ts AWD 用户手册

English

 – 31

Lightly lubricate the rubber seal on the new oil filter using new 
oil. Fit the oil filter by turning clockwise. Turn by hand until the 
rubber seal is seated. Now tighten a further half turn.

Fill with new oil according to Checking the engine’s oil level. 
Start the engine and let it idle for about 3 minutes. Now stop 
it and check for signs of leakage. Fill with oil to compensate 
for the oil held in the new oil filter.

1

Remove the transmission cover. Undo the two screws 
(one on each side) and lift off the transmission cover.

2

Check that there is oil in the transmission’s oil tank.

Rider 15T Fill if necessary with engine oil SAE 10W/40 
(class SF–CC).

Rider 15T AWD, 15Ts AWD. Fill if necessary with oil 
Synthetic 10W/50

The oil and filter should be changed by an authorised service 
representative, as described in the Workshop Manual.

Work on the system entails particular demands on 
cleanliness and the system must be vented before the 
machine is used.

The belt adjuster should be lubricated regularly using good 
quality molybdenum disulphide grease*.

Lubricate using a grease gun, 1 nipple from the right-hand 
side under the engine’s lower belt pulley, until grease is forced 
out.

With daily use, lubrication should be carried out twice weekly.

All joints and bearings are lubricated using molybdenum 
disulphide grease during manufacture. Continue to lubricate 
using the same type of grease *. Lubricate the steering and 
control wires using engine oil.

Carry out this lubrication regularly; with daily use, the 
machine should be lubricated twice weekly.

*Grease from well-known brand names (petrochemical 
companies, etc.) usually maintains a good quality. The most 
important property is that the grease provides good 
protection against corrosion.