Wright Manufacturing 26980 用户手册

Make sure the control levers are in the exact neutral 
position.  Set the parking brake, reduce the engine 
speed to idle, shut off the ignition switch to stop the 
engine and then remove the key from the ignition 
switch.  The mower is now parked.  Do not leave 
mower unattended on a sloped surface. 
 

To climb a curb, first see the Safety Instruction 
Manual section of this manual, especially the parts 
on: 
 

•  Initial Operating Safety Guidelines 

 

•  Operation In Reverse 

 

•  Operation In Forward Direction 

 
Next, raise the mower deck into the locked transport 
position.  This is the highest position for the mower 
deck.  Then drive the mower in reverse at a 45 
degree angle to the curb (with the left side of the 
mower closest to the curb) until you are within an 
inch or two of the left-rear tire hitting the curb.  Stop 
and then gradually bump into the curb with that tire 
until it is just on top of the curb.  If the tire slips even 
while lurching the mower into the curb, then the curb 
is too high and you should use ramps or find another 
way.  The mower should still be at a 45 degree angle 
to the curb.  Now, while maintaining the same angle 
to the curb, continue to back up until the right-rear tire 
is close to the curb.  Using the same technique lurch 
the right tire onto the curb.  After both wheels are on 
top of the curb, turn the mower counterclockwise and 
back up so the left caster wheel comes over and last 
should be he right caster wheel as the mower is 
twisting to the left (counterclockwise).  The technique 
works the best if you try not to drive backwards at a 
near 90 degree angle to the curb but get all of the 
wheels to go over while the mower is moving at least 
a 45 degree angle to the curb.  To drive off a curb, 
first try driving up onto it to make sure the curb is not 
too high.  If the curb is not too high, drive the right-
front caster off first while driving toward the curb at a 
45 degree angle (the curb should be to your right).  
Then, maintain that 45 degree angle so the left caster 
goes over, then the right-rear wheel, then the left rear 
wheel. 
 

 

9 

 
 
 

Never drive straight onto or off a curb.  If you do the 
whole procedure at a very sharp angle it will tend to 
minimize the contact of the mower deck with the curb 
and you will be able to more safely control the 
mower. 
 

See the Safety Instruction Manual section of this 
manual, especially the parts on: 

 

•  Initial Operating Safety Guidelines 

 

•  Operation On Slopes 

 

•  Operation In Reverse 

 

•  Operation In Forward Direction 

 

•  Operation During Zero-Radius Turns 

 

Neutral refers to the mower movement when the 
engine is set to full throttle, parking brake is off, and 
the control levers are in the neutral position.  The 
mower should not move forward or backward during 
this time.  If the mower is moving forward or 
rearward, the neutral setting must be adjusted.  The 
hydraulic pump has a Return-to-Neutral (RTN) device 
built into the linkage of the pump.  To make the 
adjustment, loosen the ¼” allen bolt and rotate the 
RTN device  until the neutral position is found and 
then retighten the ¼” allen bolt.  Use care not to over 
tighten the allen bolt.  

    

WARNING