American Standard 2425E SERIES 用户手册

752875-100 Rev. D

(2)

495mm

(19-1/2)

The variety of installations possible for this whirlpool may require framing procedures other than those shown.  Locate studs 
as required.  Ensure roughing-in dimensions are proper, plumb and square.  Provisions must be made in all installations for an 
access opening for servicing the pump and controls.  It is strongly recommended that an additional opening be provided for 
access to the drain components.

1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary. 

Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).

2. Remove the whirlpool and attach a 1 x 3 stringer to the studs, with the top of the stringer touching the traced line.

3. Install drain components to the whirlpool following the manufacturers instructions.  Before replacing your whirlpool for final 

installation, be certain that an opening has been provided in the sub-floor for the drain.  See the roughing-in drawing for 
suggested opening size and location dimensions.

4. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet.  Secure the shims 

using construction adhesive, silicone, mortar or equivalent materials.  While not a necessity, the use of a foundation base 
consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.

TILE

TILE

BEAD

STRIP

LEVELING 

STRINGER

BATH

ADHESIVE

SEALANT

WALLBOARD

NOTE:  Tile bead kit not included and must be
            purchased separately.

LEVELING
SURFACE

WATERPROOF
 SEALANT

BATH

A S   D E S I R E D

775mm

(30-1/2) 

   CUTOUT

AS

DESIRED

1486mm

(58-1/2)

CUTOUT

495mm

(19-1/2)

ACCESS PANEL

610mm

(24)

305mm

(12)

610 mm

(24)

305mm

(12)

495mm

(19-1/2)

1527mm

 (60-1/8)

762mm

(30)

8 1

3 m

m

( 3

2 )

  TUB WIDTH

L E V E L I N G
S T R I N G E R S