Dimension One Spas 01513-192 用户手册
Aquatic Fitness System
2005 Owner’s Manual
16
LED Display Window
LED Display Window: This window displays the actual water temperature.
However when you are setting the “target temperature” for your water, this
window will display the SET temperature. After a brief pause, about 5 seconds,
the window will return the display to the actual water temperature.
However when you are setting the “target temperature” for your water, this
window will display the SET temperature. After a brief pause, about 5 seconds,
the window will return the display to the actual water temperature.
Programming the Filtration Cycle
Filtration
Proper filtration is an important key to maintaining the clarity of your spa’s water. The filter system is
designed for unsurpassed effectiveness at removing debris and suspensions from the water
anytime the water is circulating.
The Aquatic Fitness System comes with six pre-programmed filtration cycles (F1-F6) and two
lockout (L1 & L2) modes. Of the six filter cycles, three cycles are in the standard mode and three
cycles are in the economy mode.
designed for unsurpassed effectiveness at removing debris and suspensions from the water
anytime the water is circulating.
The Aquatic Fitness System comes with six pre-programmed filtration cycles (F1-F6) and two
lockout (L1 & L2) modes. Of the six filter cycles, three cycles are in the standard mode and three
cycles are in the economy mode.
To change the filter cycle or to enable or disable a lockout mode, press and
hold both the WARMER and the COOLER buttons for 3 seconds. This enters
the programming mode and allows you to select your filtration cycle. The
hold both the WARMER and the COOLER buttons for 3 seconds. This enters
the programming mode and allows you to select your filtration cycle. The
display will show F1 through L2. The current filter setting
will be displayed in the window.
will be displayed in the window.
Use the WARMER and COOLER buttons to scroll up or
down between the filtering modes. The filter cycles are as
follows:
down between the filtering modes. The filter cycles are as
follows:
•
Standard Mode: F1, F2, F3
•
Economy Mode: F4, F5, F6
•
Lockout Mode: L1, L2
and
are used primarily to determine how to heat your water. When
you select a filter cycle of F1, F2, or F3, you are selecting Standard Mode. In Standard Mode the
temperature of the water is used to determine the need for heat. Whenever the temperature of the
water drops to 2°F (≅1.1°C) below your SET temperature, the pump will start and the water will heat
until the water is 2°F (≅1.1°C) above your SET temperature. In Standard Mode, heating the water is
independent of the filter cycles.
When you select a filter cycle of F4, F5, or F6, you are selecting Economy Mode. In Economy Mode,
the water only heats when the filter us running. In Economy Mode, heating the water is dependent
on the filter cycle.
When you select options L1, or L2, you are selecting the
temperature of the water is used to determine the need for heat. Whenever the temperature of the
water drops to 2°F (≅1.1°C) below your SET temperature, the pump will start and the water will heat
until the water is 2°F (≅1.1°C) above your SET temperature. In Standard Mode, heating the water is
independent of the filter cycles.
When you select a filter cycle of F4, F5, or F6, you are selecting Economy Mode. In Economy Mode,
the water only heats when the filter us running. In Economy Mode, heating the water is dependent
on the filter cycle.
When you select options L1, or L2, you are selecting the
, which allows you to
suspend filter operation or control unauthorized access to your system.