Husqvarna 70 PP 用户手册

PATTERN ADJUSTMENT

Normal spreading of materials
requires no adjustment (factory
setting “A”) unless stated on the
package. In those cases where the
spread pattern has shifted, the
pattern can be adjusted left and
right by loosening the two knobs on
the discharge chute and moving the
chute closer or farther away from
the impeller. Settings of “A, B, and
C” are provided as reference.

Knob

Discharge
Chute

Impeller

Knob

Discharge Chute
Settings

A simple visual pattern test can be made by
operating the spreader over a non-turf area
and evaluating the pattern. A more accurate
method is to place a row of common,
disposable, aluminum cake pans
approximately 1 foot on centers. Set the rate
plate at a middle setting and make 3 or 4
passes in the same direction as shown.
Pour the material collected from each pan
into individual bottles of the same size. Set
them side by side in order, and visually
inspect their volume. If the pattern is not
centered (example: volume in bottle #2 left
not equal to bottle #2 right), adjust the
discharge chute up or down as described in
“PATTERN ADJUSTMENT” section.

Once the pattern is uniform, the effective
pattern width can be determined. The

HOW TO DETERMINE SPREADER

SETTINGS AND SPREAD WIDTH

Two major factors should be considered when determining correct spreader settings of any
product:
1. The product application rate, or the amount of material applied per 1,000 square feet.

2. The effective pattern width, or the actual width in which material is applied. Label settings are a
guide and can be affected by numerous factors.

EFFECTIVE PATTERN WIDTH

effective pattern width is the distance out from the
spreader to a point where the amount of material is 1/2
the average amount in the center pans. This distance
is multiplied by 2 to achieve the total effective pattern
width.